Specifications

15000000 XciteRC Hotbee 3D Quadrocopter

Getting started

Function of receiver

1 Power wire Connect to LiPo attery Charge

2 Right front motor Connect to the right front motor The bind plug face towards right

3 Right back motor Connect to the right back motor The bind plug face towards right

4 Left back motor Connect to the left back motor The bind plug face towards right

5 Left front motor Connect to the left front motor The bind plug face towards right

6 Signal indicator light Show the bind status (green) Binding

Note:

Green light: When in the code paring status, the receiver indicator will ﬂ ash green. After code paring suc-

cessfully the green light turns solid. If the green light turns off means failure bind or has not receive the signal.

lnstruction for Charger

• The Charger is suitable for 1 or 2 cell (3.7V) Li-ion or li-polymer battery. Please plug the pin of your battery

into the jack of the Charger.

• Please plug the pin of your battery into the jack of the USB ﬁ rst and then connect to the power. Otherwise,

the LED may not become red and the voltage may be higher than 3.8V. You need to disconnect the USB

power supply and reconnect it.

• When USB power supply is well connected and battery is charging, the LED will become red. After your

battery is full charged, the LED will become green.

Notice: Only use the charger delivered with the helicopter.

WARNING: Never attempt to power the charger from an AC outlet without the use of a proper ACto DC

adapter/power supply. - ﬁ re hazard!

Steps of ﬂ ight

Installation of battery pack

Turn on the power

• Pull down the throttle stick to the lowest position.

• Turn on the power of transmitter.

• Install the battery pack in the battery compartment.

• Connect the power cable of to receive signal from transmitter.

Battery pack location

15000000-Hotbee-3D-Quadrocopter-Anleitung.indd 19 25.09.2013 13:45:18