Datasheet

h) By timer, current detection and open circuit voltage detection, charger detects full charge. When charger
detect cell is full charged, charger stop charging.
充电器必须能够通过计时，电流检测，开路电压检测监控电芯充电状态，如检测到电芯充满电，充电器需停止
充电。
1.2 Discharging 放电
a) Discharge current must be below 25A /cell.
电芯放电电流需小于25A/只。
b) Discharge end voltage must be over 2.0V.
电芯放电终止电压需高于2.0V。
c) Do not over-discharge cell below 1.5V/cell.
电芯不可过放电至电压低于1.5V。
d) Discharge temperature range should be -20 °C ~ +60°C(0.5C discharge).
电芯放电温度范围为-20 °C ~ +60°C（0.5C放电）
1.3 Environmental using conditions 电芯使用环境条件
When the cell is charged : -10°C ~ +45°C
电芯充电 : -10°C ~ +45°C
When the cell is discharged : -20°C ~ +70°C
电芯放电 : -20°C ~ +70°C
Charge or discharge out of recommended range might cause the generating heat or serious damage of cell.
And also, it might cause the deterioration of cell's characteristics and cycle life.
在超出限定温度范围进行充电或放电，会引发电芯产热或严重的损伤，也会造成循环寿命缩短及性能衰降。
1.4 Storage 储存
Any storage, cell should be in low humidity, no corrosive gas atmosphere area. And there is no press and
condensation on the cell. Best temperature range -20~+35℃.
电芯应在干燥无腐蚀性气体的环境下储存，不要让电芯承受任何压力，且不能有冷凝液体附着在电芯表面，最佳
储存温度为-20~+35℃
Long period storage, charge condition of cell is Lishen shipment charge state or discharge state.
长期存储，电芯必需处于力神出货时的状态
When stored within 1 month : -20°C ~ +45°C