Datasheet

Document NO.: WI-FHF-CS-PMIIICSL-A Page 7of 9
MODEL: CS-PMIIICSL
REV: A/1
3.4. Shipping Voltage (Inspection before shipment): ≥3.7V
(): ≥3.7V
4.Protection Capability Test Method and Request

Item

Test Method

Request

1
Overcharge Test

Apply a 5V voltage and a 1C charge
current on the battery for 10 hours.
 10hs 5V
 1C 
Battery could not be burst, burn, leak and
smoke

2
Over discharge
Tes t

Discharge the battery at 1C to cut off
voltagethen discharge with loading 30Ω
for 24hs.
 1C  30Ω  24H
Battery could not be burst, burn, leak and
smoke
. . 
3
Over-current
protection

1) The battery is fully charged to rated
capacity.

2) Load current at 0.2A/S to cut off the
output of the battery.
 0.2A/S ,
Battery could not be burst, burn, leak and
smoke
..
4
Pack Short-circuit
Protection

1) The battery is charged to rated
capacity.

2) The battery is to be short-circuited by
connecting the positive and negative
terminals of the battery with
thermocouple having a maximum
resistance load of 0.1Ω for 1h.
 0.1Ω 
 1h
Battery could not be burst, burn, leak and
smoke After charging.

After chargingthe battery can be used
normally.

5. Cell
1) Chem: Lithium-ion Cell
 
2) Spec: 103450AR/3.7V/1600mAh HY
3) 103450AR/3.7V/1600mAh HY