Specifications

Title: RF Protocol
Doc.#: XCT-RFP-EV100 (Rev. 1)
[CONFIDENTIAL]
Page 26 of 26
Related Document
• IS-4500C1-Reader-NTAG_Manual (IKSUNG ELECTRONICS)
9. FCC Statement and User Information
• This module satisfies the Part15C rule, and when integrated into the host, it must be verified that it
meets the Part 15B standard.
• This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
• Changes or modifications not expressly approved by the manufacturer (or party responsible) for
compliance could void the user’s authority to operate the equipment
• The satisfy FCC exterior labeling requirements, the following text must be placed on the
exterior of the end product.
- Contains Transmitter module FCC ID: 2AYHQ-IS-4500-C1
• This device complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators and following statements shall be included to host
user manual: This module may not be co-located with any other transmitters or antennas.
This module uses an integrated PCB loop antenna, and only this antenna should be used.
As long as conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements with this module installed.
In the event that this condition cannot be met, then the FCC authorizations are no longer considered
valid and the FCC ID cannot be used on the final product.
In these circumstances, the OEM integrator will be responsible for re-evaluating the end product
including this module and obtaining separate FCC authorizations.