Instruction manual

Introduction

XBLUE Networks

LAN vs. WAN

Remote Telephones

When connecting remote workers to the X-50 VoIP Telephone System it must have a fixed or static class A or B

IP Address. When creating a voice network (Campus Environment) the “Master” X-50 VoIP Telephone System

also must have a fixed or static class A or B IP Address. All other systems on the voice network can use Dynamic IP

addresses. This may require the ISP’s Gateway to be programmed as a Bridge or a concurrent bridge.

Remote telephones are directed

to the static IP Address of the

WAN port, which will have a

Class A or Class B IP Address.

Once registered, the WAN port

of the X-50 keeps the

telephone endpoints active by

sending “keep alive” packets to

each of the remote telephone

endpoints.

The Remote telephone should

set the Session Timer to 20

seconds.

What does that say?

The Internet Service Provider (ISP) will program their DSL/Cable

modem to be a bridge or a concurrent bridge allowing the X-50 VoIP

Telephone System to join the network parallel to the ISP’s DSL/Cable

modem. If needed, this also allows the X-50 VoIP Telephone System

to become the main router on the Local Area Network (LAN).

When connecting remote workers to a X-50 system, it must have a

static IP Address. When creating a voice network or “Campus

Environment”, only one of the X-50 systems must have a static IP

Address.

Any X-50 with a static Class A or B IP Address will support remote

workers, even if they are a node on a voice network.