User's Manual

16
Encryption Setting – WEP
Press “WEP Encryption Key Setting” to enter the “WEP Key Setting”
page shown as
- Press the “Change” button to modify the contents of “WEP Key
setting”, when it is finished, press “Apply” to save it. The button “Change” and
“Apply” is alternately shown on the same position.
- Select which key length 64,128 or 256 bits will be modified or used by “Key
Length” item.
- Select which key set will be use by the field of “Default Key ID”
Modify the 4 sets key depending on the selected key length on the field of “Key
Value”. The key value is used the hexadecimal format.
Encryption Setting – WPA
Press “WPA Encryption Setting” to enter the “WPA Setting” page
shown as Figure
- Press the “Change” button to modify the contents of “WPA Setting”,
when it is finished, press “Apply” to save it. The button “Change” and “Apply” is
alternately shown on the same position.
- Select TLS or PEAP protocol and add user name / password on the field of
“Connect information”
- Add passphrase and select the key format on the field of “ Pre-shared
Key ”
- Select the Certificate you want by the “Certificate” drop down menu
“Profile ” group:
- Select the profile that has been saved previously from the “Profile name”
drop down menu, then press “Load ” button to load the status to use.
- Write the profile name on the field of “Profile name”, and press the “Save
Current” button to save the current status on the profile.