User's Manual

ManualsBrandsXAVi Technologies ManualsElectronicswireless mini PCI

Hardwar

e Specification

for

XW202M

Module

Block Diagram:

Processor : Atheros AR2417 single chip integrated with the MAC/baseband/radio

Memory :

Serial EEPROM:16K

Antenna Interface :1x2.4G Dipole Antenna.

I/O

Interface

minpci

Feature :

-fi

reless

Access

Point

IEEE802.11b/g

2.4G

Dipole

Antenna

Sensitivity

Summary of content (4 pages)

PAGE 1
Hardware Specification for XW202M RF Module Block Diagram: Processor : Atheros AR2417 single chip integrated with the MAC/baseband/radio Memory : Serial EEPROM:16K Antenna Interface :1x2.4G Dipole Antenna. I/O Interface : minpci Feature : Wi-fi Wireless Access Point IEEE802.11b/g 2.
PAGE 2
RX Sensitivity 11g 11b Test Name Data Rate DUT Measured RX Sensitivity 6Mbps -88 RX Sensitivity 36Mbps -73 RX Sensitivity 48Mbps -70 RX Sensitivity 54Mbps -68 RX Sensitivity 1Mbps -90 RX Sensitivity 2Mbps -87 RX Sensitivity 5.5Mbps -86 RX Sensitivity 11Mbps -85 TX RF POWER Transmit Power Test Name 11g 11b Data Rate DUT Measured Transmit power 6Mbps 17 (+1.5/-1.5) dBm Transmit power 36Mbps 16 (+1.5/-1.5) dBm Transmit power 48Mbps 15 (+1.5/-1.
PAGE 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following " Contains TX FCC ID: RYUXW202M ". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement has to also be available on the label: This device complies with Part 15 of FCC rules.