User's Manual

X7968r / X7967r / X7927r / X7922r User’s Guide
84
Attribute Value
Whip Possible Values if compiled for Whip Serial:
Serial or Inactive
Possible Values if compiled for Whip TCP:
TCP or Inactive
Possible Values if compiled for Whip Serial/TCP:
Serial, TCP or Inactive
Whip Active Indicated state of whip. Possible values are
Inactive, SerialActive and TCPActive
Action An action given when ActivateLine is set to Start.
Possible values are Startup, SpectrumReverb,
SpectrumMedely or SpectrumPilot
Standard Indicates the preferred standard compliance.
Multimode indicates that the device
automatically detects the other end as one of the
supported standards.
Utopia Interface Level1 – Utopia Level 1 internal framing is used
with the DSP
Level2 – Utopia Level 2 internal framing is used
with the DSP
EC FDM Mode EC – enables Echo Cancellation. This setting is
necessary if your device is connected to a high
speed CO.
FDM – enables Frequency Division Multiplexing
Max Bits Per Bin The maximum number of bits per bin. This can
be any value between 1 and 15
Tx Start Bin A value that indicates the lowest bin number
allowed for transmit signal
Tx End Bin A value that indicates the highest bin number
allowed for transmit signal
Rx Start Bin A value that indicates the lowest bin number
allowed for receive signal
Rx End Bin A value that indicates the highest bin number
allowed for receive signal
Rx Auto Bin Adjust Disable – the bin settings configured as the
RxStartBin/RxEndBin parameters are used
Enable – DSP automatically adjusts the bin
selection for receive signal
Tx Attenuation A value between 0dB and 12dB that indicates
the transmit power attenuation
Bit Swap Disable – disables the adjustment of the
number of bits assigned to a subcarrier without
interrupting data flow
Enable – enables the adjustment off the number
of bits assigned to a subcarrier without
interrupting data flow
Max Down Rate A value that sets the maximum downstream rate
for those applications where it is necessary to
limit the downstream data rate
Physical Port A value between 0 and 14 that sets the Utopia
Level 2 Utopia address
Retrain Disable – disables full retrain capability
Enable – enables full retrain capability