User's Manual

X5671 User’s Guide
30
Click Add to add a rule of Incoming IP Filtering.
Check Remove and click Remove to remove the specified entry.
Figure 35: Add - Incoming IP Filter Setup
Global Setting
4 Enter the Filter Name
4 Select the Protocol from the selection list.
4 Enter the Source IP Address and Subnet Mask (range of IP addresses) of packet
4 Enter the one port or multi ports (port range)
4 Enter the Destination IP Address and Subnet Mask (range of IP addresses) of
packet
4 Enter the one port or multi ports (port range)
4 Select the WAN interfaces which will be applied with this incoming IP filter rule.
4 Click Save/Apply