User's Manual

X5671 User’s Guide
22
IP over ATM (IPoA)
Figure 23: WAN Connection,MER Configuration
To configure the IP over Ethernet settings:
4 Enter the WAN IP address and WAN Subnet Mask.
4 Select “Use the following default gateway” and then also enter the gateway IP
address and Use WAN Interface where packets will be sent to.
4 Select “Use the following DNS server addresses” and then also enter the IP
addresses of Primary DNS server and Secondary DNS server.
4 Click Next
The NAT configuration and WAN Setup Summary page will show up. Please refer
related pages above for reference. Click Save if correct and click Back to restart the
configuration again.