User's Manual

X5671 User’s Guide
19
4 Select the Encapsulation Mode from the list (LLC/SNAP-BRIDGING,
LLC/SNAP-Routing or VC/MUX)
4 Click Next
PPP over ATM (PPPoA) and PPP over Ethernet (PPPoE)
Figure 19: WAN Connection, PPPoA or PPPoE Configuration
To configure the PPPoA or PPPoE settings:
4 Enter the User’s PPP Username and Password
4 Enter the Service Provider Name if any
4 Select the Authentication Method used during negotiation, default is AUTO.
4 Check “Dial On Demand” if you do not need PPPoA or PPPoE connection
always ON and enter the timeout value to disconnect the PPPoA or PPPoE
connection when connection is idle and timeout. If you enter “0”, zero for the
timeout value, it means always ON.
4 Check the “IP extension” if your ISP requests to enable it, otherwise do not
select it. This is a special service to forward IP address assigned by remote to
the local device in the LAN.
4 Check the “Use Static IP address” and enter the IP address if your ISP assigns
a fixed IP address to you. Otherwise, do not select it.
4 Check to enable “Retry PPP Password on Authentication Error”.
4 Check to enable “PPP Debug Mode”
4 This “Bridge PPP frames between WAN and Local Ports” is checked in default.
4 Click Next