User's Manual

X5669WUP3 User’s Manual Version 1.0
13
2. Quick Setup
This model supports Quick Setup for user to set up the modem/router
to work with the provide service from ISP or TELCO.
STEP1> Click the “Quick Setup”, This Quick Setup will guide you
through the steps necessary to configure your DSL Router.
STEP2> Select the check box “DSL Auto-connect” to enable DSL
Auto-connect process. If you want to input VPI/VCI and choose the
protocol to connect your service, just leave this check box disable, then
input VPI, and VCI numbers. Click “Next” to go to next step.
STEP3> Choose the Connect Type, the specific page will show up,
refer to chapter “WAN Setup” to go ahead next STEP for different
configuration.
<Note> If the configuration is bridge encapsulation, there is no need
to configure any more parameters. Only need to use the third party dial-up
software to connect the Internet.
This model supports：PPPoA、PPPoE、MER、IPoA、Bridging. For detail
configuration information, please check the following chapters
configuration guide.