User manual
6
audio. We do not recommend using switch-
ing-type regulators as a linear PSU is always
-
modules introduce digital noise to the GND rail
keeping the common resistance as low as pos-
as they invite noise and interference between
modules.
Avoid feeding very quiet signals to your Ti-
miszoara and amplifying the output signal to
compensate. Conversely, observe the adc clip
indicator to avoid overdriving the unit. Use
input attenuators to adjust the signal’s am-
plitude and keep in mind that some program
algorithms may cause internal clipping. In
general, it is physically impossible to prevent
distortion when a loud continuous signal is
-
-
tion, when signal quality is important, many
long reverb and delay effects are unsuitable
for drone-like input, especially raw wave-
forms from oscillators.
FILE STRUCTURE & NAMING
You can use the factory card included with the
module, or a different card to add more effect
programs. Remember to format a new card
can be written in the assembler language of
the FV-1 chip or designed visually using the
SpinCAD Designer, and they must be compiled
-
each program may have no more than 128
delay memory. note: Xaoc Devices do not of-
fer technical support for third-party software.
Timiszoara requires that each compiled bina-
a separate folder with the same name and as-
of all eight programs together with the three
names of their parameters, separated with
Each effect program can have up to three pa-
rameters controlled by the three par am slider
potentiometers and their corresponding CV
inputs. bank names may be up to eight charac-
ters long. The same goes for parameter names.
program names may be up to nine characters
-
ara, we recommend following the structure
FACTORY PROGRAMS
Timiszoara comes with a microSD card hold-
ing factory programs covering a wide range
pitch shifters, distortions, glitching, and stut-
tering. Many of these effects perform in stereo
from utilizing most of the resources for a sin-
gle signal path. In such a case, the program
downmixes the stereo signal to mono before
processing. Keep in mind that the total amount
of memory in the FV-1 chip allows for only one