User manual

4
menu
navigation
 inputs are normalled to one another,
with the normalization occurring before the
input attenuators; therefore, it is necessary to
adjust both input attenuators even with a sin-
gle mono signal. The left
10
and right
11
signal outputs are located just below. There
is a single clipping detection LED
12
at the
bottom of the panel.
This LED illuminates when the inputs, out-
puts, or signal inside the CPU is too hot. In
some programs
-
tinually.
Above the screen, there are four slider po-
tentiometers corresponding to the four CV
     param 1, 2, 3
potentiometers
13
and jacks
14
are direct
controls for the three parameters of the cur-
rent program with their names displayed
    mix potentiometer
15
and CV input
16
control the analog wet/dry
mixer that combines the original signal with
the processed one.
NAVIGATING THROUGH THE CARD
During normal operation, turning the encod-
er selects the effect program from the cur-
rently loaded bank of up to eight programs
   program is only loaded when
      
encoder. Pressing and holding the encoder
knob for one second displays the content of
the memory card as a folder list, with each
folder corresponding to a single bank 
    cancel option at the end of
the list for returning to the last loaded bank.
A B
C
G
F
H
DE
main screen
bank library screen
service menu screen
Legend:
A
program position within the bank
B
program name
C
program parameter names
D
on icon indicates whether the program
is currently active
E
Current bank name
F
on icon indicates whether the bank is
currently active
G
Entering the bank
H
Fixed Spin FV-1 internal bank