TIMISZOARA voltage controlled dsp effektor operator’s manual rev. 1970/1.
module explained SALUT power connection; however, flipping the 16pin header may cause serious damage to other components of your system because it will short circuit the +12V and +5V power lines. Always pay particularly close attention to the proper orientation of your ribbon cable on both sides! note: There is a second, 10-pin header at the back of the module for connecting an expander.
front panel overview fig.
menu navigation Both inputs are normalled to one another, with the normalization occurring before the input attenuators; therefore, it is necessary to adjust both input attenuators even with a single mono signal. The left 10 and right 11 signal outputs are located just below. There is a single clipping detection LED 12 at the bottom of the panel. C A B E D fig. 2: main screen This LED illuminates when the inputs, outputs, or signal inside the CPU is too hot. In some programs (e.g.
Press the encoder knob to confirm the selection. If there is no card present, only two options are available: spin demo (the internal bank of the Spin chip) and cancel. The spin demo bank is also available with the card inserted in the module. Although the programs included in this bank are nothing spectacular, they are more than adequate in an emergency such as a faulty or lost memory card. switch back to 1 after the 8th position.
audio. We do not recommend using switching-type regulators as a linear PSU is always the best solution, and hybrid (switching+linear) is a good compromise. Also, some digital modules introduce digital noise to the GND rail of the bus board, so its quality is critical (i.e., keeping the common resistance as low as possible). Finally, avoid using "flying bus" cables as they invite noise and interference between modules. er).
factory programs second of delay, which must be split between channels. Though, some included combo programs feature a different effect in each channel. two parallel delay lines with various feedback paths, thus offering different time-mangling flavors. Besides the usual controls over delay time and feedback, our parallax delays have a third parameter called skew that adjusts the time displacement of the two delay lines with regard to one another.
MAIN FEATURES WARRANTY TERMS XAOC DEVICES WARRANTS THIS PRODUCT TO BE FREE OF DEFECTS IN MATERIALS OR WORKMANSHIP AND TO CONFORM WITH THE SPECIFICATIONS AT THE TIME OF SHIPMENT FOR ONE YEAR FROM THE DATE OF PURCHASE. DURING THAT PERIOD, ANY MALFUNCTIONING OR DAMAGED UNITS WILL BE REPAIRED, SERVICED, AND CALIBRATED ON A RETURN-TO-FACTORY BASIS.
