Owners Guide

Reset Switch
975-0004-01-02 Rev D 61
Reset Switch
Use the Reset Switch on the side of the chassis for the
following conditions.
• To manually initiate battery equalization in Charge
Control mode, press and hold the Reset Switch until the
red and green LED start to flash.
• To manually suspend battery equalization in Charge
Control mode, press and hold the Reset Switch until the
red and green LED stop flashing.
• To reset following an error condition, press and release
the Reset Switch.
• To reset following a low-voltage disconnect, press and
release the Reset Switch.
See “Reconnecting to Loads” for additional information
about reconnecting to loads.
Important: The LED will light red only in Load Control
mode; never in Charge or Diversion mode (unless it is reversed
upon reinstallation).
Figure 3-3 Reset Switch
Reset Switch