Multiple Output Power System Programming Manual XMP 2600

Commands and Queries Reference Alphabetical reference
RIPL? return the current programmed output ripple for the Power Module.
The result is two decimal numbers: the first being the level (0t o 2)
and the second being the frequency (1 to 7).
Syntax: RIPL?
Parameters none
Category Settings Type: Sequential
ROM? return a string identifying the XMP 2600. The result is “XMP 2600
x.xx dd/mm/yy” where: x.xx is the firmware revision code and
dd/mm/yy is the firmware date code.
Syntax ROM?
Parameters none
Category System Type: Sequential
SEQ start / stop sequence program execution.
Syntax SEQ <int>
Parameters a value of “0” will stop and a value of “1” will start
the Sequence Program.
Category System Type: Sequential
SEQ? return the current state of the Sequence Program. The result is a single
decimal number of value “0” if the program is not running. If the
program is running then the result will have two elements: the first is
the number (1 to 99) of the step being executed and the second is the
amount of time left until the step’s operation will be performed
(h:mm:ss).
Syntax SEQ?
Parameters none
Category System Type: Sequential
SEQCLR clear all Sequence Program Steps (only if program is not running).
Syntax SEQCLR
Parameters none
Category System Type: Sequential
XMP 2600 Programming Manual
rev. 1.1 59