RV Series Remote Control Owner's Manual RC/GS RC7
Table Of Contents
- Important Safety Instructions
- Introduction
- Installation
- Configuration
- Set Idle
- Battery Capacity
- Battery Type
- Max Charge Rate
- Set Shore Power
- Remote Setup
- LCD Contrast
- Set Clock (RC/GS Only)
- Select Genset (RC/GS Only)
- Generator Start (RC/GS Only)
- Generator Stop (RC/GS Only)
- Thermostat Start Enable and Disable (RC/GS Only)
- Begin Gen Quiet and End Gen Quiet (RC/GS Only)
- Saving Setup Choices
- RV Series Inverter/Charger and RC/GS and RC7 Setup
- Auto Gen Start Setup (RC/GS Only)
- Operation
- Status LEDs
- LCD Screen
- Buttons
- AC Source Messages
- Genset Error Messages (RC/GS Only)
- Inverter Mode Messages
- Charger Mode Messages
- Inverter/Charger Error Messages
- Meters Display
- System Status Messages
- Preparation for Storage
- System Status Messages
- Generator Status Messages (RC/GS Only)
- System Status Display
- Meters Display
Operation
46 975-0210-01-01
RC/GS and RC7 User’s Menu Summary
System Status Messages
Generator Status Messages (RC/GS Only)
AC Source Inverter Mode Charger Mode Error Mode
System Status:
Waiting for AC
System Status:
Searching
System Status:
Bulk Charging
System Status:
Otemp/Less Load
System Status:
AC Available
System Status:
Inverting
System Status:
Absorption Chrg
System Status:
Overload
System Status:
Float Charging
System Status:
Hi Bat/Stop Chrg
System Status:
Equalizing
System Status:
Lo Bat/Start Chrg
System Status:
Charger Fault
AC Source Inverter Mode Charger Mode Error Mode
Genset Status:
Pending Genstart
Genset Status:
MAN STOP ONLY
Genset Status:
Gen Wont Start
Genset Status:
Pending Gen Stop
Genset Status:
Gen Quiet Fault
Genset Status:
Cranking Genset
Genset Status:
Starter Cooldown
RC-GS_manual.book Page 46 Thursday, May 26, 2005 4:58 PM