RV Series Remote Control Owner's Manual RC/GS RC7
Table Of Contents
- Important Safety Instructions
- Introduction
- Installation
- Configuration
- Set Idle
- Battery Capacity
- Battery Type
- Max Charge Rate
- Set Shore Power
- Remote Setup
- LCD Contrast
- Set Clock (RC/GS Only)
- Select Genset (RC/GS Only)
- Generator Start (RC/GS Only)
- Generator Stop (RC/GS Only)
- Thermostat Start Enable and Disable (RC/GS Only)
- Begin Gen Quiet and End Gen Quiet (RC/GS Only)
- Saving Setup Choices
- RV Series Inverter/Charger and RC/GS and RC7 Setup
- Auto Gen Start Setup (RC/GS Only)
- Operation
- Status LEDs
- LCD Screen
- Buttons
- AC Source Messages
- Genset Error Messages (RC/GS Only)
- Inverter Mode Messages
- Charger Mode Messages
- Inverter/Charger Error Messages
- Meters Display
- System Status Messages
- Preparation for Storage
- System Status Messages
- Generator Status Messages (RC/GS Only)
- System Status Display
- Meters Display
iii
About This Manual
Purpose
The purpose of this Owner’s Manual is to provide
explanations and procedures for installing and operating the
RV Series Remote Controls—RC/GS and RC7.
Scope
The Manual provides safety guidelines, planning and setup
information, installation procedures, as well as information
about operating the unit. It also contains information about
configuring and operating the RV Series Inverter/Charger
with the RC/GS or RC7.
Audience
The Manual is intended for anyone who needs to install and
operate the RC/GS or RC7. Installers should be certified
technicians or electricians.
Organization
This Manual is organized into four chapters.
Chapter 1 contains information about the function and
features of the RV Series Remote Controls.
Chapter 2 contains information and procedures to install the
RV Series Remote Controls.
Chapter 3 contains information about configuring the RV
Series Remote Controls.
Chapter 4 contains information and procedures to operate the
RV Series Remote Control.
RC-GS_manual.book Page iii Thursday, May 26, 2005 4:58 PM