RV Series Remote Control Owner's Manual RC/GS RC7
Table Of Contents
- Important Safety Instructions
- Introduction
- Installation
- Configuration
- Set Idle
- Battery Capacity
- Battery Type
- Max Charge Rate
- Set Shore Power
- Remote Setup
- LCD Contrast
- Set Clock (RC/GS Only)
- Select Genset (RC/GS Only)
- Generator Start (RC/GS Only)
- Generator Stop (RC/GS Only)
- Thermostat Start Enable and Disable (RC/GS Only)
- Begin Gen Quiet and End Gen Quiet (RC/GS Only)
- Saving Setup Choices
- RV Series Inverter/Charger and RC/GS and RC7 Setup
- Auto Gen Start Setup (RC/GS Only)
- Operation
- Status LEDs
- LCD Screen
- Buttons
- AC Source Messages
- Genset Error Messages (RC/GS Only)
- Inverter Mode Messages
- Charger Mode Messages
- Inverter/Charger Error Messages
- Meters Display
- System Status Messages
- Preparation for Storage
- System Status Messages
- Generator Status Messages (RC/GS Only)
- System Status Display
- Meters Display
Configuration
22 975-0210-01-01
Saving Setup Choices
Once the setup options are complete, press and hold the
Setup/Menu Item buttons (see Figure 3-19) for approximately
five seconds or until the screen clears. The setup choices will
be saved in the inverter/charger’s non-volatile memory 20
seconds after exiting the Setup menu if no other actions are
taken. These settings will be preserved until changed.
Note: The generator start and stop settings will not be saved if
the RC/GS is disconnected or DC power is lost.
Figure 3-19
Setup/Menu Item Buttons
Meter Mode
Menu Item
Setup
RC-GS_manual.book Page 22 Thursday, May 26, 2005 4:58 PM