RV Series Remote Control Owner's Manual RC/GS RC7
Table Of Contents
- Important Safety Instructions
- Introduction
- Installation
- Configuration
- Set Idle
- Battery Capacity
- Battery Type
- Max Charge Rate
- Set Shore Power
- Remote Setup
- LCD Contrast
- Set Clock (RC/GS Only)
- Select Genset (RC/GS Only)
- Generator Start (RC/GS Only)
- Generator Stop (RC/GS Only)
- Thermostat Start Enable and Disable (RC/GS Only)
- Begin Gen Quiet and End Gen Quiet (RC/GS Only)
- Saving Setup Choices
- RV Series Inverter/Charger and RC/GS and RC7 Setup
- Auto Gen Start Setup (RC/GS Only)
- Operation
- Status LEDs
- LCD Screen
- Buttons
- AC Source Messages
- Genset Error Messages (RC/GS Only)
- Inverter Mode Messages
- Charger Mode Messages
- Inverter/Charger Error Messages
- Meters Display
- System Status Messages
- Preparation for Storage
- System Status Messages
- Generator Status Messages (RC/GS Only)
- System Status Display
- Meters Display
Installing the RC/GS and RC7
975-0210-01-01 9
8. Wait for the screen to show the message “Waiting for
AC.”
9. Place the
ON/OFF switch on the RV Series Inverter/
Charger to the
ON position.
10. Reconnect the RV Series Inverter/Charger to the AC
source. After a brief delay, the remote will display a
system status message similar to Figure 2-4.
Important:
The remote will not operate the RV Series Inverter/
Charger if the
ON/OFF switch is in the OFF position.
Figure 2-4
System Status Message
System Status:
AC Available
RC-GS_manual.book Page 9 Thursday, May 26, 2005 4:58 PM