C40 Faceplate

975-0123-01-01 Rev A

To Mount the Remote:

1. Use the remote as a template and mark the positions for the screw

holes. Mark the open area to be cut out for the circuit board.

2. Drill out the four screw’s holes and prepare wire access

opening/clearance. If using a double-gang, non-metallic, outlet box,

install it according to the manufacturer’s instructions.

3. Connect the communications cable (from the C-Series controller).

4. Secure the faceplate using screws (and anchors if necessary).

Figure 10

Mounting the Remote

Mounting Holes

SAMPLE - Double-gang,

non-metallic, outlet box