C40 Faceplate

975-0123-01-01 Rev A

Cable Installation (Step 2)

Connect the display to the controller using the serial communications

cable provided. The cable is a six-conductor telephone cable with

modular-type connectors (RJ-15). Although any telephone-type cable

will work, the cables provided with the displays use stranded and

tin-plated wire for better performance and longer life.

The following instructions are illustrated in Figure 6.

To connect the Faceplate to the C-Series controller:

1. Remove the front cover of the C-Series controller by removing the

four screws on the front cover of the unit.

2. Remove the LED on the circuit board of the C-Series controller

next to the RJ-15 Port just above the

BATTERY POSITIVE connector.

If the LED must be replaced in the future, it will operate in either

orientation, except if replaced incorrectly, the color of the status

LED will be reversed.

3. Insert the serial communications cable from the faceplate into the

RJ-15 Port.

4. Align the faceplate on the front of the C-Series controller so that the

holes for the faceplate match.

5. Secure the faceplate in place using the four screws removed in

Step 1.