RF2IR RF Base Station Quick Start Installation Instructions ATTENTION: Requires the XTR39 to operate.
Welcome! The RF2IR base station is the ultimate Xantech accessory to the Xantech XTR39 Color LCD remote. It’s a receiver that accepts the Radio Frequency output of the XTR39 remote and translates it into IR and RS232 command signals that can control virtually any home electronic device. The RF2IR makes it simple to set up a reliable and sophisticated multi-room control system that is easily controlled by the intuitive LCD touch screen control of the XTR39 RF capable remote.
RF2IR Diagram (Front) IR LED, RF LED: Flashes when emitting IR and RS232 commands Quick Start Instructions Step 1. Plug the (4) 283M emitters (included) into the port labeled IR output 1 thru 4 on the back of the RF2IR. Next, place the associated 283M emitter head directly over the IR eye on the proper source component to be controlled. Step 2. Plug the RS232 Adapter Cable (if required) into the RF2IR port labeled RS232. Next, connect the DB9 plug to the source component to be controlled.
RF2IR Configuration (Channel Address) The Channel Address on the RF2IR cannot be programmed using Universal Dragon. Located on the bottom of the RF2IR device is a rotary switch. Turn this switch to select the desired Channel Address. The switch is labeled in HEX notation. “A” stands for Channel Address “10”. “B” stands for Channel Address “11”. The Channel Address increments with the alphabet until it ends at “F”, which is “15”.
Xantech Limited Warranty (Effective for products sold after July 1, 2006) Xantech Corporation (“Xantech”) warrants to the holder of a valid proof of purchase as the first end-user purchaser (“You”), its products to be free from defects in materials and workmanship for the periods specified below from the date of purchase. This limited warranty extends only to You for product purchased and used in the United States of America.
