Owner's Manual

xantech
INSTALLATION
QUICK-ST ART
A typical system will use an IR receiver, several emitters, and a power supply
all connected to a connecting block.
1. Connect the IR receiver to the "IR RCVR" port on the connecting
block. The 'red' connector is installed to the 'red' plug.
Note: In some extended distances, additional 3-conductor may be
required and can be connected to the terminals on the connecting
block.
2. Connect the Emitters to the connecting block. The 'yellow' connector
is installed to the 'yellow' plug.
3. Connect the power supply to the connecting block.
DL Series
IR Receiver
!
-
Hand Held
Remote
IR Photodiode
(mounted on or
near cabinet in an
inconspicuous
location).
REMOTE ROOM APPLICATION
To 120V AC
(tmwrtched)
Satellite Receiver
=•
2830 Emitter
2830 Emitter
0
One application is to locate the IR receiver in a remote room. This will give the
end-user the ability to control audio/video equipment from a location where
the remote control no longer has the ability of direct line-of-sight.
The IR receiver will need the 3.5mm stereo type mini plug removed to extend
the wire run to the connecting block. A 3-terminal block can be purchased
separately to connect the IR receiver to the connecting block with a 3-
conductor inter-room cable in between.
IR SIGNAL (TIP)
2
r==:i=za IRSIGNAL
(REOOR
WHITE STRIPE)
+12VDC
(MIDDLE WIRE)