Owner's Manual

xantech
Cause: Solution
Reposition the Emitter so that it is directly
1. Emitter placement is incorrect. over the components sensor window.
Emitter placement is correct
but the signal is overpowering
2. the unit or there is bleed-
through from other emitters
close by.
Consult the components owners' manual of
the unit for the exact location of the IR
Sensor Window.
Reposition the Emitter to a position that is
suitable for the unit. Use a 283 or 286D Blink
style emitter (they have a lower output than
non-blink emitters 282 and 284M). If the
components do not need to be controlled
directly without an IR Repeater system
(components are located in an equipment
closet), place a Mouse Emitter Shield cover
over the Emitter (PN#MS1 ). The rounded
(non-stick) side of the emitter is a hi-output
side and can reflect off other devices and
overpower some components IR Sensors. If
using a CB 12 connecting block, try a 789-44
connecting block. This has a series resistor
at the output, which will limit current to the
Emitter.
12