Installation Guide

FRONT AREA
1 Printer Paper Cover
2 4” Display
3 Magnetic Strip Reader (MSR) slot
4 Power Button (Press > 3 seconds to power on/off)
5 Smart Card Reader (SCR) slot
REAR AREA
6 Charging contact points
7 USB port (type C) for charging
8 Camera for 1D/2D barcode scanning (Optional)
9 Battery Compartment
AT-100 Power spec:
Input: 5V DC, 2A
Power Adapter spec:
Input: 100 ~240 Vac
Output: 5V DC, 2A
Caution: Use only the AC adapter approved and provided by XAC Automation
Corporation for use with this device. Use of any other AC adapter may cause a risk of
fire or explosion.
Operating Temperature: 0
o
C to 40
o
C
3. POWER ON/OFF THE DEVICE
To power on the device: Long press the Power button (Figure 2) > 3 seconds and the
device screen will be activated.
To power off the device: Press the Power button > 3 seconds to shut down the device.
Figure 2
NOTE: When device is in idle or suspend mode, short press power button will wake up the
device.