UNATTENDED TERMINAL XUPT-303 INSTALLATION GUIDE
1. XUPT-303 PACKAGE CONTAINS - xUPT-303 Cable clamp (Figure 1) 2 Hand screws (Figure 2) 2 RS232 to RJ 12 cable (Figure 3) P90 dedicated cable (Figure 4) – Used to connect and supply power to XAC P90 (Optional) Figure 1 2. Figure 2 Figure 3 Figure 4 PORT CONFIGURATION There are several ports at the back side of terminal (Figure 5). - Power jack - 1 Ethernet port - 3 COM port - 4 USB port - 1 mini USB port NOTE: COM3 port is dedicated to XAC Secure Hybrid Reader module. Figure 5 3.
Figure 7 Step 2: Tight the hand screw on the right side of cable clamp (Figure 8) until the cable clamp can move loosely. Figure 8 Step 3: Plug each cable into corresponding port, and collect each cable into cable channel (Figure 9). To secure the cables, fasten two hand screws (Figure 10). Figure 9 5. Figure 10 POWER ON THE TERMINAL Step 1: Connect the power cord to the power adapter Step 2: Plug the power adapter into an electrical outlet or into a surge suppressor (recommended).
6. USING THE CONTACTLESS CARD READER Contactless reader antenna is around the display. It will light up and blinking the 1st LED when xUPT-303 is powered on and that means reader is working normally. Place contactless card near the display (Figure 14). The contactless antenna should detect the card and read the card data. Note: Make sure the xUPT-303 contactless antenna is away from other contactless antenna at least 8 inches to avoid interfere. Figure 14 7.
FCC statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
