User's Manual

1. BEFORE STARTING
Find the power input on the right side of the terminal. Connect the plug from the power adapter into the power
input (Figure 1). Plug the pow er adapter into a 120-volt electrical outlet or into a surge suppressor
(recommended) after the power cord is connected to the power adapter.
Figure 1
 Operating Temperature: 0 °C to 40 °C
 RTC battery spec. : 3V, CR2032
 Adapter: LITEON,PA-1061-71, I/ P: 100-240Vac, 47-63Hz, 1.5A, O/ P: 12Vdc, 5.0A
Caution: Risk of explosion if the battery is replaced by an incorrect type. Please dispose of used battery
according to the instructions.
W arning: A shielded-type pow er cord is required in order to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception. It is essential that only the supplied power cord be
used.
2. POWER ON
Plug the pow er cord into the power jack and plug the power adapter into a 120-volt electrical outlet or into a
surge suppressor (recommended) after the pow er cord is connected to the power adapter. Press the “Cancel”
button at the front of device (Figure 2) until the system is booted up.
Figure 2
3. PORT CONFIGURATION
There are several ports at the back side of TP72-HUB (Figure 3).
󴖰 USB Host x 4
󴖰 USB Device x 1
󴖰 RS232 port x 1
󴖰 Cash drawer port (RJ11)
󴖰 Ethernet port (RJ45)
Figure 3
4. LOADING THE PAPER