User's Manual

Figure 9 Figure 10
4. USING THE MAGNETIC CARD READER
Magnetic Card Reader
Find the card reader slot at the right side of terminal. Slide the card in either direction through the slot without
stopping. If the card swipe fails, check the position of the magnetic stripe and slide the card again (Figure 11).
Contactless Card Reader
Contactless reader antenna is around the display and PIN pad. It will light up with blue color signal when terminal
is powered on and that means reader is working normally. Put contactless card to approach the antenna of card
reader (Figure 12) for reading the card data during transaction.
Smart Card Reader
The Integrated Circuit Card (ICC) reader is located at the most bottom end (Figure 13). Please make sure that ICC
side is facing upward when inserting into the slot.
Figure 11 Figure 12 Figure 13
5. USING THE KEY PAD
To enter numbers or letters, simply press the appropriate key. For example, to type the letter B: Press and release [B]
twice times, then display shows B (Figure 14).

Figure 14
6. INSTALLING THE SAM CARD
There are four SAM slots located on the left side of the device (Figure 15). Before insert the SAM card, please turn off
the device. Insert the SAM card in the slot in figure 16. Make sure SAM cards inserted in the right direction (Figure
16).
Figure 15 Figure 16
7. INSTALLING THE PRIVACY SHIELD
The privacy shield of the T103 shows as figure 17. We need to tear the tap around the privacy shield (Figure 18), and
please stick the privacy shield on around the 15-key keypad (Figure 19).
The terminal is compliant with PCI privacy screen design requirement when the detachable privacy shield is
installed on the device. Any change to or removal of this privacy shield will cause security concerns.
Figure 17 Figure 18 Figure 19