User's Manual

1. READER DEVICE SETUP
Plug the USB (Figure 1), RS232 RJ12 (Figure 2) or RS232
DB9 (Figure 3) of the contactless reader C200 to the host
(PC or terminal).
Note: Please also plug power cord to cable if it’s RS232
RJ12 type.
One is power input; another is a port for devices connected
to terminal (Figure 3). (Adapter: Leader Electronics Inc.
/MU12-2050200-C5, MU12-2050200-A1; Input: 100-240V,
50/60Hz, 0.5A; Output: 5V, 2A)
Input voltage/ Current: 5V/500mA for USB,
12V/1A for RS232 RJ12,
5V/1A for RS232 DB9
Operating/ Storage temperature: Operating: 0℃~40
Storage: -20℃~60℃
All lights (blue, yellow, green, red and four blue boundary
lights) turn on as soon as the USB is connected (Figure 4).
Caution: Risk of explosion if the battery is replaced by an
incorrect type. Please dispose of used battery according to
the instructions.
When only blue light and boundary lights (Figure 5) are on
and the monitor shows “XAC CityPass”, C200 is ready to
use.
2. TEST TRANSACTION
A test transaction should be performed upon installation to
ensure trouble-free operation of the device.
Yellow light turns on when card is not yet detected well.
(Figure 6)
Green light turns on when card is detected (Figure 7)
Red light turns on when system error occurs.
Figure 1
Figure 2
Figure 3
Figure4
Figure 5
Figure 6
Figure 7
3. MAINTENANCE
Stringent quality-control standards are followed in manufacturing
all reader devices.
Numerous tests are performed on each unit before leaving the
factory to ensure quality and reliability.
4. RETURNING READER DEVICE
If you need to return your device for service or replacement,
contact your service provider or sales representative for
instructions.
Note: Do not try to service, repair or adjust the device in any
way; doing so will void your warranty.