User's Manual

1. POWER ON THE 8006 PIN PAD
There are three model of communication interface for 8006L2-3CR: USB interface cable, RS232
interface cable, POE interface cable.
¾ POE interface cable: There is a fixed POE interface cable at the top end of 8006
device as Figure 1 for pow er and communication connection to the terminal
or PC. POE interface cable can supply the power by two options below
Figure 1
a. From RJ45 port
If Ethernet cable is able to supply the power, plug on the RJ45 cable into RJ45 port
(Figure 2) can power on the device.
b. From Micro USB port
Micro USB cable can also supply pow er to the device by plugging on the micro USB
cable into micro USB port (Figure 3).
Figure 2 Figure 3
Note: Turn off or unplug the terminal/ PC whenever you connect or disconnect the PIN
Pad. Be sure the terminal/ PC is not processing data when pow ering down.
¾ 2 in 1 USB 2.0 plug with Micro USB jack
USB 2.0 plug is mainly used to connect the device to PC for ActiveSync (Figure 4) while
micro USB jack is for power supply (Figure 6).
¾ 2 in 1 RS232 (DB-9) plug with Micro USB jack
It is mainly used to connect the device to PC for serial port communication (Figure 5) while
micro USB jack is for power supply (Figure 6).
Figure 4 Figure 5 Figure 6
 Input rating: DC 5V, 500mA (without QR module) and/ or DC 48V, 270mA (supplied
by Ethernet Interface Adapter)
 Operating Temperature: 0ºC ~ 40 ºC
2. INSTALLING THE SAM CARD
Remove the back cover (Figure 7), and then slid in the SIM card and make sure the card is
installed correctly (Figure 8). Close the back cover to complete SAM card installation.