User's Manual

3. USING THE PIN PAD
Press numeral key to enter password if needed. Then press green [ENTER] key to finish password
key-in. Press red [CANCEL] key to exit from presently status (Figure 7).
Note: If the PIN is entered incorrectly, press [CANCEL] and re-enter it.
Figure 7
4. INSTALLING THE PRIVACY SHIELD
The privacy shield is installed on the device, and the keypad will be separated from the LCD.
(Figure 8)
Figure 8
5. CLEANING
Periodically clean the PIN Pad device with a clean cloth dampened with water and a mild soap or
cleaner. Do not use harsh chemicals.
6. MAINTENANCE
Stringent quality-control standards are followed in manufacturing all PIN Pad devices. Numerous
tests are performed on each unit before leaving the factory to ensure quality and reliability.
7. RETURNING THE 8006L1-1CRA PIN PAD
If you need to return your PIN Pad device for service or replacement, contact your service
provider or sales representative for instructions.
Note: Do not try to service, repair or adjust the PIN Pad device in any way; doing so will void
your warranty.
Caution: Risk of explosion if the battery is replaced by an incorrect type. Please dispose of used
battery according to the instructions.

Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
FCC Caution: A ny changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.