PINPAD 8006L1-1CR SERIES INSTALLATION GUIDE
1. CONNECTING THE 8006L1-1CR PIN PAD The 8006L1-1CR device can be used to connect with PC/ terminal. It supports RS232, USB interfaces via different cable types such as DB9 (Figure 1) and standard USB (Figure 2) connector. Input voltage/ current: 5V/ 500mA for 8006L1-1CR USB or 12V/ 500mA for 8006L1-1CR DB9 AC adapter for DB9: HON-KWANG ELECTRIC Co.,LTD HK-AX-120A200-EU Input: 100-240Vac/ 0.8A, 50/ 60Hz. Output: 12V/ 2.
. USING THE PIN PAD Press numeral key to enter password if needed. Then press green [ENTER] key to finish password key-in. Press red [CANCEL] key to exit from presently status (Figure 7). Note: If the PIN is entered incorrectly, press [CANCEL] and re-enter it. Figure 7 4. INSTALLING THE PRIVACY SHIELD The privacy shield is installed on the device, and the keypad will be separated from the LCD. (Figure 8) Figure 8 5.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
W arning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. W arning: If the device, 8006L1-1CR, is used without the detachable privacy shield, the following criteria needs to be met by the Installed Environment of the PED for complying with the PCI privacy screen design requirement: A.
