User manual

Setting up the device

1. Unpack all parts from the packaging.

2. Connect the retaining bracket (3) with the base (4) using the screw (8). Place the

washer (11) between the retaining bracket (3) and the base (4). Insert the screw

downwards through the retaining bracket (3) and the base (4) and tighten the

screw.

3. The integrated battery has to be charged now. You can use the power adaptor (10)

or the recharger cable 12 V/24 V (9) for charging. When using the charging cable

12 V / 24 V (9) with a car power socket, also refer to the manual of your car.

4. Open the cover of the charging socket (6) and plug in the cable of the power

adapter (10) or the charging cable 12 V / 24 V (9). Connect the device with a wall

socket or a car lighter adapter, depending which charging method you want to

use. The integrated battery of the device will now be loaded.

5. When the charging process is complete, the LED (7) lights permanently green.

The construction light is now ready for use.

6. Remove the cable and close the cover of the charging socket (6).

7. You can now switch on the device by pressing the On/o/dimm-switch (5).

8. If the capacity of the integrated battery decreases below 20 %, the LED (7) starts

to blink RED/GREEN and the emitted light starts to icker. In this case, charge the

battery of the device (see point 3).