User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety and warranty
- 3 Product description
- 4 Commissioning
- 5 XorayaSuite
- 6 Maintenance
- 7 Storage, transport and disposal
- 8 Appendix
USER MANUAL
XORAYASUITE
163
Add condition:
Select an already configured Signal (9). (➔ Settings)
Select the Relation (10) between signal and value.
Select the Relation type (11).
Depending on the relation type, specify the Raw value or the time
(in ms). (➔ Changing the numbering system)
Combine multiple conditions:
Click Add condition (3).
Configure this condition as described above.
Select the Operator (12) that combines this and the previous condition.
If required, repeat the above steps to combine further conditions.
Operator precedence
According to the rules of Boolean algebra, the AND
operator (&&) precedes the OR operator (||). You can
influence precedence by parentheses.
Add parentheses:
Click the desired conditions and operators to mark them blue.
Click Parenthesise selection (7).
or
Click Move selection to right (5).
Remove parentheses:
Click the desired conditions and operators to mark them blue.
Click Move selection to left (6).
Visualisation of parentheses
The GUI displays conditions of the same precedence
level, meaning parenthesised conditions, also on the
same horizontal level. The corresponding operator is
connected to the left border.
Being further to the right is equivalent to a higher
precedence. Therefore, Parenthesise selection (7) and
Move selection to right (5) have the same effect.