Product Manual

Installation: for 3-Way operation - Create New
Note: A 3-Way system, by definition, means two existing wall switches which operate one single light (can be multiple lights if all come on
together). In this NEW installation instruction, there are no traveler wires between switches. The XPT1 Transmitter will be connected to HOT
and NEUTRAL only. It will communicate with the Master Switch via existing power wires.
1. Turn power OFF at Circuit Breaker.
2. Pull-out the existing single-pole wall switch from the switch box.
3. Inspect inside the wall switch box for existence of white neutral wire(s) capped-off. If no white neutral wires exist, STOP. You CANNOT use the
WS13A unless you run a neutral wire to this box.
4. Remove the existing wall switch. Two wires remain protruding out of switch box. One is HOT; the other goes to the light/load. They may be the
same color.
5. With Breaker ON, determine which wire is HOT. Use a voltmeter and measure between ground and each wire individually. One will read 120V,
the other 0V.
6. With Breaker OFF, connect a white neutral wire to the NEUTRAL Terminal. You may have to tap into a neutral wire bundle with an additional
white wire 6-8" long.
7. Connect the HOT wire to the LINE Terminal; connect the other wire to the LOAD Terminal.
8. There will be no connection to the CONTROL TERMINAL needed.
9. Re-check all connections, Turn power ON at Circuit Breaker.
10. Press switch paddle once, you will hear switch CLICK and light should turn ON. Press paddle again, you will hear switch CLICK and light should
turn OFF.
11. You are now ready to control the switch with an X10 Remote Control Module: desktop, wireless handheld, Security Panel, etc. The default
address is "A1". If you wish to change the code, the Code Dials are behind the paddle. Remove the paddle with a small flat screwdriver applied to
the side of the paddle at the center fulcrum point. Insert screwdriver in small gap space between switch plate and paddle and flip the paddle up
from its side.
12. Install the XPT1 Wall Transmitter Switch. You will need an existing or new switch box which has power run to it.
13. With Breaker OFF, connect the XPT1 Black wire to HOT, connect the XPT1 white wire to Neutral. Turn Breaker ON.
14. Press the XPT1 Switch "ON" position once, and the light connected to the Master Switch should turn ON, (the Master will CLICK). Press the
XPT1 Switch "OFF" position once, and the light should turn OFF (the Master will CLICK).
15. To change the XPT1 Address Code, remove the Keypad, with fingers pulling from bottom, then turn the dials, with small flat screwdriver, to the
desired Address Code. Keep the WS13A and XPT1 codes identical.
16. Mount the Switch(s) and Transmitter(s) in the wall box(s) and attach the switch cover plates.
NOTE: You can use additional XPT1 Wall Transmitter Switches to augment new 4-Way or greater systems. You will need additional wall switch boxes
with power run to them. Then install the XPT1 Transmitter, connecting HOT and Neutral.
120 DAY LIMITED WARRANTY x10.com (X10), a division of Authinx Inc., warrants this product to be free from defective material and
workmanship for a period of 120 days from the original date of purchase at retail. X10 agrees to repair or replace, at its sole discretion, a
defective product if returned to X10 within the warranty period and with proof of purchase. If service is required under this warranty:
Call 1-888-384-0969, visit www.x10.com, or email [e-mail].