Video Receiver for use with X10 Wireless Camera Systems MODEL VR36A OWNER'S MANUAL
INTRODUCTION CONTROLS AND CONNECTIONS The VR36A Video Receiver works with X10's Wireless Cameras. The Camera converts video into wireless radio frequency (RF) signals and transmits them (even through walls) to the Video Receiver which you connect to a TV anywhere in your home (up to 100 ft. away from the Camera). The Video Receiver converts the signals back to video signals which are fed through a cable to your TV's Video input jack.
FINE TUNING C ONNECTING UP 1. Connect a Video cable to the VIDEO OUT jack on the Video Receiver. Connect the other end to your TV's VIDEO IN jack. If your TV does not have a Video IN jack, you will need to purchase an RF modulator, or connect as shown in the diagram below. 2. Plug the Video Receiver's Power Supply jack (the power supply with NO code wheels) into the Video Receiver and plug the power supply into a 120 volt wall outlet.
TROUBLESHOOTING If you do not see a picture on your TV: Check that the Receiver and the Camera are on the same letter channel (A, B, C, or D). On the Receiver the switch is on the bottom. On the Camera the switch is located under the rubber plug on the base of the unit. Make sure you replace the plug afterwards if you intend to use the camera outdoors. There is a power light on the front of the Receiver. Check that the power switch on the side of the Receiver is ON. Check that the Camera is turned on.
12 MONTH LIMITED WARRANTY X10.COM A DIV. OF X10 WIRELESS TECHNOLOGY, INC. (X10) WARRANTS ITS PRODUCTS TO BE FREE FROM DEFECTIVE MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE (1) YEAR FROM THE ORIGINAL DATE OF PURCHASE AT RETAIL. X10 AGREES TO REPAIR OR REPLACE, AT ITS SOLE DISCRETION, A DEFECTIVE X10 PRODUCT IF RETURNED TO X10 WITHIN THE WARRANTY PERIOD AND WITH PROOF OF PURCHASE. IF SERVICE IS REQUIRED UNDER THIS WARRANTY: 1. CALL 1-800-675-3044, OR VISIT WWW.X10.COM, OR E-MAIL SALES@X10.
