Audio/Video Receiver for use with X10 Wireless Camera Systems MODEL VR31A OWNER'S MANUAL
INTRODUCTION The VR31A Audio/Video Receiver works with X10's Wireless Cameras. The Camera converts video and sound into wireless radio frequency (RF) signals and transmits them (even through walls) to the Audio/Video Receiver which you connect to a TV anywhere in your home (up to 100 ft. away from the Camera). The Audio/Video Receiver converts the signals back to video and audio signals which are fed through a cable to your TV's COAX or Audio/Video input jacks.
C ONNECTING UP IF YOUR TV IS ALREADY HOOKED UP TO A DBS RECEIVER OR OTHER A/V DEVICE 1. Connect a set of Audio/Video cables to the A/V OUT jacks on the Audio/Video Receiver. Connect the other end to your TV (use Yellow for video, and either L or R channel for audio). V ID E O A U D IO TO TV TV 2. Plug the Audio/Video Receiver's Power Supply jack (the power supply with NO code wheels) into the Audio/Video Receiver and plug the power supply into a 120 volt wall outlet.
TROUBLESHOOTING If you do not see a picture on your TV: In most cases, relocating the Camera or Receiver a few feet is enough to avoid the source of interference. Check that the Receiver and the Camera are on the same letter channel (A, B, C, or D). On the Receiver the switch is on the bottom. On the Camera the switch is located under the rubber plug on the base of the unit. Make sure you replace the plug afterwards if you intend to use the camera outdoors.
12 MONTH LIMITED WARRANTY X10.COM A DIV. OF X10 WIRELESS TECHNOLOGY, INC. (X10) WARRANTS ITS PRODUCTS TO BE FREE FROM DEFECTIVE MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE (1) YEAR FROM THE ORIGINAL DATE OF PURCHASE AT RETAIL. X10 AGREES TO REPAIR OR REPLACE, AT ITS SOLE DISCRETION, A DEFECTIVE X10 PRODUCT IF RETURNED TO X10 WITHIN THE WARRANTY PERIOD AND WITH PROOF OF PURCHASE. IF SERVICE IS REQUIRED UNDER THIS WARRANTY: 1. CALL 1-800-675-3044, OR VISIT WWW.X10.COM, OR E-MAIL SALES@X10.
