User guide

PLATESCOPE
26
If a mistake was made and you would like to re-measure the patch, use the Navigation
Ring to move the highlight focus to Delete icon and press the Select button. The last
measurement taken on the strip will be deleted. Each patch is deleted individually, starting
with the last measured.
8. Press the Measure button or use the Next Arrow icon to activate targeting mode.
9. Locate the instrument’s target window on the 10% patch of the target strip using the
reticule icon in the screen for positioning.
10. Press the Measure button to take the measurement. The screen displays a filled in box over
the 10% patch and the measurement data.
11. Repeat steps 8 – 10 until the remaining five patches on the strip have been measured. The dot
percentages of each patch measured are displayed in the screen for each patch measured.
12. Use the Navigation Ring to move the highlight focus to Next Arrow icon and press the
Select button. The screen returns to the main strip screen where the time and date stamp is
displayed.
13. Select the Exit icon to exit the strip mode.
Next arrow
Exit
Dot % for each patch