User guide

PLATESCOPE

5. Press a Measure button to take the measurement. The screen displays a “checkmark” over

the patch icon if the patch was successfully measured.

NOTE: If a minus symbol (-) appears in the patch location instead of a checkmark, you will

need to re-measure the patch.

If you would like to re-measure the patch, use the Navigation Ring to move the highlight

focus to Delete icon and press the Select button.

6. Use the Navigation Ring to move the highlight focus to the Next Arrow icon and press the

Select button. The next part of the sequence requires you to measure the seven patches of

the 175 LPI verification step wedge. The seven patches are used to verify the performance of

the instrument.

7. Press the Measure button to activate targeting mode.

8. Position the instrument’s target window on the 2% patch of the 175 LPI step wedge, using

the reticule icon in the screen for positioning.

9. Press a Measure button to take the measurement. The screen displays a checkmark over the

2% patch if the patch was successfully measured.

Checkmark

indicates a

successful

measurement

Next Arrow

Checkmark indicates a

successful measurement

Next arrow

Location indicator

Delete patch measurement

Verification wedge (175 LPI)