Technical data

Settings

............................

5.7 – 5.7.1

5.7 Printer

The D190 remission densitometer can be connected to different types of printers or computers.

........................................................................................................................................

The D190 and the printer must be configured correctly.

• Printout of measuring results (refer to chapter 4.1.4).

• Baudrate setting (refer to chapter 5.8.1).

• Handshake setting (refer to chapter 5.8.2).

• Baudrate setting of printer

• Handshake setting of printer

• Data format setting of printer

........................................................................................................................................

The Printer function allows you to carry out the following settings:

........................................................................................................................................

• Printer or PC selection. The PC protocol does not contain control characters for the printer (escape

sequences). If your printer can not be selected in the D190, you can select a similar printer (e.g. a

printer of the same printer manufacturer). If print results are bad with this selection, please select

‘PC’; the printouts should be good but without any graphics.

• Selection of printer protocol.

• Entry of user specifications.

5.7.1 Printer or PC

Procedure:

• Select the menu line Settings by turning the <Control ball> and confirm the selection by pressing

the <Measurement key>.

• Select the menu line Printer by turning the <Control ball> and confirm the selection by turning the

<Measurement key>.

• Select the menu line Printer/PC by turning the <Control ball>.