Technical data

Settings

............................

5.3 – 5.3.1

5.3 Jobs

........................................................................................................................................

For density difference measurements, it is necessary to measure or enter reference values.

Tolerance values can be overwritten. Four jobs with four to eight references each can be

defined. The names of the jobs can be freely selected. The names of the references one to

four are preset. The names of the references five to eight can be freely selected. Preset

default reference values and tolerance values may be set.

........................................................................................................................................

5.3.1 Job definition

Procedure if no job has been defined:

• Select the menu line Jobs by turning the <Control ball> and confirm the selection by pressing the

<Measurement key>.

• The display shows Define job in reverse video.

• Activate the function by pressing the <Measurement key>.

• Four job names are shown on the display.

• Select the desired job by turning the <Control ball> and confirm the selection by pressing the

<Measurement key>.

• The entry field of the current job name is shown in reverse video on the display.

• Use the <Control ball> to select the menu line

o in the entry field.