Technical data

Function selection
............................
3.3 – 3.4
3.3 Function selection
• Select the desired menu line by turning the <Control ball>.
• Activate the selected function by pressing the <Measurement key>.
........................................................................................................................................
The menu line Print header will be displayed if the D190 printer protocol is switched on and if
the function print header is activated.
........................................................................................................................................
3.4 Heading printout
........................................................................................................................................
• Configure and connect your printer to the D190 remission densitometer.
• Configure data interface under Settings
k Data interface.
• Select the D190 printer protocol under Settings
k Printer k Printer protocol.
• Configure the header Settings
k Printer k Header.
........................................................................................................................................
Procedure:
• Select the menu line Print header by turning the <Control ball>
• Activate the printout of the header by pressing the <Measurement key>.