Manualshelf

Technical data

ManualsBrandsX-Rite ManualsdensitometersD19C Standard > D19C Full Upgrade
111112113114115116117118119120
Device settings
............................
6.6 – 6.6.1
6.6 Setting protection
........................................................................................................................................
In the D19C you can protect the settings by means of a password (optional feature which is
not included in all instruments).
........................................................................................................................................
........................................................................................................................................
If the settings are protected, you will be able to enter the menu ‘Settings’ only by using a
password. Please don’t lose this password! Otherwise please contact your GretagMacbeth
representive.
Refer to 5.1.1.2 for entering the settings using the password protection.
........................................................................................................................................
6.6.1 Activate the setting protection
Procedure:
• Select the menu line Setting protection by turning the <Control ball>.
• Activate the selected function by pressing the <Measurement key>.
• Select the menu line Protection on/off by turning the <Control ball> and confirm the selection by
pressing the <Measurement key>.
• Select <on> or <off> by turning the <Control ball> and confirm the selection by pressing the
<Measurement key>.
• If your selection is <on>, you have to define the password: Select the menu line Code by turning
the <Control ball> and confirm the selection by pressing the <Measurement key>.
• Select the characters of the password by turning the <Control ball> and confirm each selection by
pressing the <Measurement key>.
• After entering the password select the menu line OK by turning the <Control ball> and confirm the
selection by pressing the <Measurement key>.
• Select the menu line Return by turning the <Control ball> and press the <Measurement key>
several times to return to the main menu. If the setting protection is switched on, you will need the
password for entering into the menu Settings.