Technical data

Device settings

............................

6.5.3

6.5.3 New functions

........................................................................................................................................

If you are an owner of a D19C, you can bye additional functions for your instrument. You can

bye and enter all functions described in this manual into your D19C. This is possible at least 10

years after delivery of the instrument.

If you buy a new function you get a code number which has to be entered into the D19C. After

entering the code, the function is available in your densitometer.

........................................................................................................................................

Procedure:

• Select the menu Settings

k Device settingsk Available functions.

• Select the menu line New functions by turning the <Control ball> and confirm the selection by

pressing the <Measurement key>.

• Select the menu line with the square by turning the <Control ball> and confirm the selection by

pressing the <Measurement key>.

• Select the numbers of the code by turning the <Control ball> and confirm each selection by pressing

the <Measurement key>.

• After entering the whole code select the menu line OK by turning the <Control ball> and confirm the

selection by pressing the <Measurement key>.

• If the code was OK, the message Function released is shown on the display.

• If the code was wrong, the message Password wrong is shown on the display.

• Select the menu line Return by turning the <Control ball> and press the <Measurement key>

several times to return to the main menu. The new functions are shown on the display.