Instruction manual

STRIP OPERATION
4-3
View Strip Data
Control strip data consists of the “actual” values measured by the instrument.
Control strip data is viewed after a strip measurement or by selection from
the Main Menu (p2).
Viewing Data after Control Strip Measurement
1. Press key l (Stain) to page through RGB data fields of the strip.
2. After viewing data, press key llll (exit) to exit.
exit
0.29 0.34 0.54
Stain
Red Green Blue
Viewing Control Strip Data from View Menu
1. Press key ll (view) located on Function Menu page (p2) to enter View
Menu screen.
FUNCTION MENU
p2
view xmit
2. Press key ll (pap), key lll (film), or key llll (bal) to select strip category.
VIEW MENU
balpap film
3. Press key ll or key lll (Stain) to page through RGB data fields of the
strip. After viewing data, press key llll (exit) to exit to the View Menu, or
simultaneously press key lll and key llll (MENU) to exit to the Main
Menu.
exit
VIEW
>
0.29 0.34 0.54
Stain
Red Green Blue
NOTE: CHANNEL IS EMPTY appears in the display if no control strip data
is available to view.