User Manual

Key Blockers (not compatible with X-keys Sticks)

Unused keys may be replaced with optional key blockers.

Feet

The included angled feet may be snapped in to the bottom of the XK-24, XK-

60 and XK-80 to give it a slight tilt in either portrait or landscape orientation.

Other Products from P.I. Engineering

X-keys XK-24 – 24 programmable keys

X-keys XK-60 – 60 programmable keys

X-keys XK-80 – 80 programmable keys

X-keys XK-128 – 128 programmable keys

X-keys XK-12 Joystick – 12 keys with a precision joystick

X-keys XK-12 Jog & Shuttle – 12 keys with jog & shuttle

X-keys XK-3 Foot Pedal – three programmable pedals

X-keys XK-4 Stick – four programmable keys

X-keys XK-8 Stick – eight programmable keys

X-keys XK-16 Stick – sixteen programmable keys

X-keys XK-68 Jog & Shuttle – 68 keys with jog & shuttle

X-keys XK-68 Joystick – 68 keys with a precision joystick

X-keys Matrix Board – 128 switch points

Y-mouse PS/2 to USB adapter

FCC Declaration of Conformity

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) this device must accept any interference

received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

residential installation. This equipment generates, uses, and can radiate radio frequency

energy and if not installed and used in accordance with the instruction manual may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and the receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

 Consult the dealer or an experienced radio TV technician for help.

Any changes or modifications not expressly approved by the manufacturer could void the

user’s authority to operate the equipment.