XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
B 4.2 Disassembly Page 8
C.V.D.S & HUB CARRIERS
8) Remove the rear shock assemblies. From each side, take out the bottom
bolt, then remove the plastic nut from the top. Save shocks and their bolts
& nuts. Don’t lose the aluminum bushing in the bottom shock eyelet! Now
remove the upper mounting bolts and bushings. Save everything for re-
use.
9) Twist the camber link inner ball cups off their ball studs, then remove the
ball studs. Leave the cups on the camber links and the links on the hub
carriers; save the ball studs and any washers that were under them.
10) Remove the rear hub carriers with the C.V.D. assemblies still in them and
the camber links attached to the hubs. Do this by removing the tiny 2-56
button head screw (left photo) and pushing the hinge pin out with an Allen
driver. Careful not to lose the shims on the hinge pins! (center photo)
Save these entire assemblies for re-use: The hub carriers, shims, hinge
pins, and especially those pesky little screws. (right photo)