XFCK030 X-6 Cubed Conversion Kit Manual V1.0

K 030 X – 6 Cubed
Instruction Manual v1.0
B 4.2 Disassembly Page 6
X – 6 CUBED INSTRUCTIONS
B 4.2 DISASSEMBLY
GENERAL
1) You are too experienced to require photos for these first few instructions.
Remove the body. We suggest you store the clips by putting them back in
the body mounts. Remove the wheels. Again, store the nuts by putting
them back on the axles. We store things this way often so they are right
where we need them when we are looking for them.
2) Remove the gear cover. You will not need this part or the screws. Take
the pinion off the motor, then unsolder and remove the motor. Of course
you’ll need these parts again, so we suggest you put the pinion with your
other pinions and put the screws back in the motor for storage.
3) Remove the electronics, including the battery, servo, E.S.C., radio
receiver, and antenna. Save them all for re-use. Do not remove the servo
mounts from the servo, just remove the two flat head screws from under
the chassis and save those screws by putting them back into the servo
mounts. Disconnect the servo link from the bellcrank, leaving it attached
to the servo horn. Do not disconnect the horn from the servo. We
suggest you clean the servo tape from the electronics.
You should now have a rolling chassis as in this photo: